Richard Clark wrote in
:

On Wed, 12 Sep 2007 22:20:43 GMT, Dave Oldridge
wrote:

I made a 160m loop out of LMR400, using the capacitance of the
inner-to- outer conductor to resonate it. Made it two turns and wound
a gimmick match out of flat 4-wire phone cable onto it to fire it up.
Very narrow, but reasonably effective. Better than a hamstick, I
think. It's about 3 feet in diameter.

...

Yes, my 160m loop is almost too narrow for SSB.

Hi Dave,

Radiation resistance for a 1 meter loop at 1800 KHz is 23 microOhms.

Two turns makes it 92 micro-ohms.

If I were to interpret your BW to be 2 KHz (an antenna Q of 900); then
the Ohmic resistance would be 0.0225 Ohms (0.002 Ohms/foot). This
resistance is on par with #13 wire which has considerably less surface
area than the LMR400.

I'm not sure it is as wide as 2khz. LIS, it's not really suitable for
SSB. It's OK on CW, though.

The added resistance resides, undoubtedly, in connections (or maybe
the gimmick); and if you drove it out, you might find your loop
suitably more efficient for CW-only. Unfortunately, it might become
an arc-gap transmitter.

I'd not recommend it for low power.

As an aside, I can't visualize the gimmick's relation to the
inner/outer conductors. You have any close-up pictures?

Look at Ted Hart's loop design in the old Antenna books. I sort of
patterned it after that. The 80 meter 1-turn loop is a bit bigger and,
of course works a bit better. Don't get me wrong, these were test-of-
concept antennas and I don't use them for my working antennas. If I were
to build a working loop for 80m, I'd do it out of 2-inch copper pipe and
make it as large as practical.


--
Dave Oldridge+
ICQ 1800667