Thread
:
Vertical Loading Coil
View Single Post
#
2
November 12th 07, 05:22 PM posted to rec.radio.amateur.antenna
John Ferrell
external usenet poster
First recorded activity by RadioBanter: Jul 2006
Posts: 199
Vertical Loading Coil
On Sun, 11 Nov 2007 15:57:33 -0800,
wrote:
Hi, Designing a 33' portable 80M vertical. Modelled it, and said I
needed a 37 uH loading coil around halfway up. Wound one using a 2"
cardboard form and #18 teflon insulated wire. My Z meter said it was
37 uH, upon placing in service, the resonant point was fairly close to
the design point on the antenna.
My question: I was hesitant to to put the coil in service because my
MFJ259B would not confirm the inductance value. It said the Z of the
coil was than 650 ohms or that L(X=0), all dependent on frequency.
I could never get a good indication of the Inductance. I suspect this
is due to self resonance of the coil, but don't know. I calculated
the Inductance of the coil given the F and Z reading on the 259B and
it came close to 37uH, but still (inductive reactance) X=0. Anyone
know what is going on?
Thanks,
Gary N4AST
Did you have the test frequency set to a point in the 80M band on the
MFJ 259? The operating frequency does affect the measured inductance.
If it is not too much of a hassle, put the antenna into a temporary
operating position and put the analyzer at the feed point to determine
if things are close.
The Q of the coil is going to be important if are to achieve an SWR
below 2:1.
A quick run of the numbers indicated you need 43 turns of #18 wire on
a 2 inch form that is 4 inches long.
Since you did not specify the diameter of the mast, I choose 1.5
inches which computed to a resonant point of 3.375 mhz.
You may find my experiment at
http://dixienc.us/28FtVert/28FtVertical.htm
interesting...
John Ferrell W8CCW
"Life is easier if you learn to
plow around the stumps"
Reply With Quote
John Ferrell
View Public Profile
Find all posts by John Ferrell