"John Tartar" wrote in message
. 70...


Thanks for all the suggestions. However, I should have mentioned that I'm
using Windows 98.

1) gEDA appears to be only for Linux & Mac.

??? I'm running it on XP (and Linux, too) -- there are standalone compiles
as well as Cygwin.

2) I installed PCB artist, but thee's no component libraries, and the
prices for the small runs are about $100 higher than Express PCB

Again, where are you getting this stuff?? The main problem seems to be that
there are so many libraries that it is difficult to locate the part you want
amidst all the noise

...