On Dec 10, 6:25 pm, Scott wrote:
The post has been out there a while and we all assume it's a typo (I've
never seen the original poster reply about that) but 1/2 a centimeter
would make HUGE plates...1/2 a mm sounds MUCH more realistic...

Scott





Denny wrote:
On Dec 10, 6:58 am, Scott wrote:

Here in the USA, 0.020" aluminum is a standard thickness.

http://www.aircraftspruce.com/catalo...eet_2024t3.php

Scotthttp://corbenflyer.tripod.com/
Gotta Fly or Gonna Die
Building RV-4 (Super Slow Build Version)

terry wrote:

Rough and ready. One inch is 'about' 25mm?
So 0.5 mm = 1/50th of inch?
Which = 0.02 inches?
That correct?
So 0.016" would be close????????????

--

Uuuh, I thought the OP said .5 CM, not MM... Slight difference by X10

denny

--
Scotthttp://corbenflyer.tripod.com/
Gotta Fly or Gonna Die
Building RV-4 (Super Slow Build Version)- Hide quoted text -

- Show quoted text -

Ahhhh jeez, there you go again - wanting reality! And on usenet to
boot...

denny / k8do