That's ok..............it is good that we hooked up. Now, about that
3030.............it sounds like one of the bandswitching diodes for the MW
range has blown. This is the reason that MW reception is dead. If you remove
the cover from the radio and have the front panel facing you, the
preselector cicuits will be on the left hand side of the top board.
The MW section will be the second filter section from the front panel of the
radio. This section is easily identified, since there are not tuned
circuits.....you will see three resistors that make up the 10dB attenuator
that is used instead of a filter section. Why AOR chose this silly
implementation on the MW band escapes me. I replaced this attenuator network
with a MW bandpass filter of my own design, and the radio had no overload
problems. While I was at it, I replaced all of the switching diodes in the
front end with 1N5767 PIN diodes. It worked pretty well after these mods.
Feel free to shout me down directly from that other e-mail address if you
have any questions!

Pete

Yo Pete. could be my isp bounced the email. sorry. i haven't heard
from Richard at AOR yet. was hoping you might have the road map.
how bout -driftermick at yahoo dot com- if you have it. or a url.
thanks Pete.

Drifter...