In article . 196,
"Ed_G" wrote:


Ed, you would be Much Better Off, if they would allow you to use (2)
runs of Coax, side by side up the mast, and connect only the Center
Conductor of each, to the tuner, with the shield left open on each end
and sealed against water intrusion. Even if taped to the aluminum
mast.
This would provide a much better situation than a single coax feed.
Also if you are stuck with a single coax, then make SURE, that the
shield side of the coax is connected to the Ground Stud of the tuner.



Well! That was part of my original question in this thread! I had
intended to do just that, but some here seemed to steer me toward a
single coax, including SGC personnel. I do NOT think we have any
decent ground at all available anywhere near the roof location where
this antenna mast will be located, so I was unsure if the twin coax
feed would be OK without grounding the shields. Left floating, I
don't know what effect, if any, we will have for incidental radiation.
One thing for sure, it won't be any worse than using a single coax with
no balun at the feedpoint.


Ed

"Left Floating" so that there is less Capacitance to RF Ground, and more
distance between the vertical parallel Feedlines. It would even help
if you can use twin Coax Runs, to put them on opposite sides of the
Aluminum Mast, which would give you more separation with the same
Coupling Capacitance to the Mast. Capacitive coupling to RF Ground,
is the Killer here, and you MUST reduce that, as much as possible,
if your system is going to have any chance at reasonable operation.

--
Bruce in alaska
add path after fast to reply