Not sure about the higher frequencies but in the HF band we absolutely need
an antenna coupler that matches the impedance to the selected frequency. If
a coupler fails we can barely throw a signal a few miles whereas when the
coupler does it's job we can bounce a signal off of the ionosphere at night
for a few thousand miles.

Claude
Montreal

"billcalley" wrote in message
...
Hi All,

I always hear that antennas have to be matched to their radio, but
in receivers (such as FM and shortwave radios) I see mostly long
random length antennas used, and these antennas -- be they a
telescoping whip or a long wire out a window -- are used over some
really wide bandwidths. How is this possible if an impedance match
must always be maintained for radios? And since there cannot be a
good match over such wide bandwidths with any (typical) wire antenna,
what is the downside to using these completely unmatched long antennas
for receivers? (Poor gain patterns with lots of nulls? Lower
sensitivity due to bad noise figure or gain match for any LNA or
frontend amp? Degraded overall antenna gain)?

Thanks; I'm very confused on this subject!

-Bill