Finally got the batteries charged, discharged and charged again. I have
managed to fully charge them now.

How long should they last for with the MFJ-259 left on continuously being
used?

Is it normal to only get 10 - 15 minutes worth of on time before getting the
low battery warning on the MFJ?

Also the MFJ-259 is new. What is the best ways to check it to make sure its
working properly?

Thanks


"Highland Ham" wrote in message
news
If you're using your MFJ-259 for several hours per week, standard 2600
NiMH cells may be a good choice. If you use the analyzer only
occasionally, I think you'll be happier with either NiCd, or
low-self-discharge 2000/2100 NiMH.
================================================== ===
NiCad and NiMH batteries (usually having a capacity exceeding 400mAh)
which need to perform at all times I normally charge constantly with 10
mA when not in use. This trickle charge level keeps them in good
condition.
I have a Wahl ISOTIP 2.4 V soldering iron which in this way is always
available. When in use I switch the charging current to 300 mA

Frank GM0CSZ / KN6WH