Buck wrote:
On Sat, 19 Apr 2008 12:24:14 -0700, Roy Lewallen
wrote:

Buck wrote:
You wrote the program, so I am not arguing with you, I will check it
out again. I sure feel I remember that being a restriction. Funny
thing is, that I haven't set learning the program to a higher priority
since I didn't think it would model what I want to experiment with,
which is parallel wires/poles.

I'll have to look into that more.

Perhaps you're remembering a restriction with MININEC-based programs,
which had problems with close spaced parallel wires.

Thanks for the heads up.

BTW what is the upgrade cost for 4.0 and 5.0 from 3.0?
Sorry, the upgrade price is available only to people who have purchased
EZNEC. You can find information on purchasing a new program at
http://eznec.com.

Thanks
Buck
n4PGW
Roy Lewallen, W7EL

My wife purchased it at a hamfest about three years ago before we
married.

Buck, send me an email so we can get this sorted out off-line.

Roy Lewallen, W7EL