View Single Post
  #25   Report Post  
Old April 22nd 08, 10:05 PM posted to rec.radio.amateur.antenna
Radio_Dick Radio_Dick is offline
external usenet poster
 
First recorded activity by RadioBanter: Jan 2008
Posts: 9
Default Use of type 31 ferrite as coax common mode choke

The following is a copy of my message posted earlier to the general
group, but I had wanted to preply directly to this topic as it's very
pertinent to the discussion of ferrites, so here is the message again
(sorry if you see this twice).

Greetings All,

Saw the posts about Mix 31 ferrites, which I use on my mobile
installations with good results, using a HiQ 5/160 antenna and Icom
IC7000.
If anyone is interested, I recently posted on my web site a document
the describes the installation of ferrites for HF installations: :
www.repdesign.us ,
(go to the "Downloads" page (left side of screen towards the bottom),
and go to the third group to download or simply open to read the PDF
document).

This is based on what has worked well for me, information from Fair
Rite's web
site, and ideas from various past posings. Also listed is a partial
list of suppliers - as always check the prices as they can vary a
lot!

Check it out and let me know (direct email) if you have any other
suggestions and if you find this useful, as this is meant to be a
"continous improvement" document. I also plan to write additional
guidelines as time permits.

73,
Dick Post, N7EMW
www.repdesign.us


On Apr 21, 10:21*am, "J. Mc Laughlin" wrote:
I looked through saved messages and the only reference to type 31 ferrite
(Fair-Rite) was in March of 2005. *That reference had to do with ignition
wires.

Recommendations for HF choking ferrites have centered on the 70 series with
type 43 being favorably recommended for the upper portion of HF and VHF.
However, Fair-Rite seems to be recommending type 31 for HF. *See Figure 26
in:http://www.fair-rite.com/newfair/pdf/CUP%20Paper.pdf

Am I missing something? *It seems to me that for the purpose of choking
common mode current (on the outside of the outer conductor of coax) from 3
to 25 MHz one should prefer the use of type 31. *This is a receiving
application with a long run of coax.

73, * *Mac * N8TT

P.S. *I will also appreciate ideas about places to purchase ferrite in
addition to Mouser.

--
J. McLaughlin; *Michigan, USA
Home: