Drake R8 POP..On turn on
dxAce wrote:
Dave wrote:
dxAce wrote:
D Peter Maus wrote:
dxAce wrote:
Justis wrote:
I just had my R8 in for a checkup(I bought it used recently) and the
receiver
has a pop in the speaker when turning it on.
The tecky says this is normal with all R8's. Is this true? I think not.
He also said the alignment is A1...can I believe him now? !@#$%
Sometime it even emits a short duration and diminishing in volume, bronx
cheer when turned on.
Anyone experienced this with their set?
Saw your post earlier today on the Yahoo group and I tried mine out and no pop
here, nor bronx cheer.
Where did you have yours serviced?
No pop with my R8A, either. Only the clean click of a relay, and then
audio.
Checked my R8A (listening to the guys on 3850 with it now) and no problem with it or
the R8B which was checked earlier.
As for alignment, a quick, although not definitive test, is to tune
in a station of known frequency and stability. WWV is fine for this.
Tune to the center of the channel--make sure the Passband Offset is
centered, too--with each of the filters in place, and check for
frequency readout. If you're on frequency, with equal skirts on each
side, alignment is pretty close. Do this on each WWV frequency. If
results are fairly consistent at each dial position, your alignment is
likely pretty good.
Does Homey hear the relay?
Did Rickets take his meds?
You really need to seek professional help, asswipe.
|