Art Unwin wrote:

...
By the way, on my page

unwinantennas.com/

I describe how to make an antenna even smaller than that made by the
threads initial poster
I also supplied SWR measurements for frequencies between 2 and 100
Mhz. The wire I used was a random length and the results should be
duplicated with a couple of wavelengths for the lowest frequency.
Isolated spot frequencies can be attained by the use of a jumper. Such
antennas can also be made in small sheet form and other configurations
Wire used for such antennas do not have to be made of wire with
mechanical thickness since no external mechanical stresses are
involved.
Nuff said. I'm gone !

My point can be summed up quickly; where is this antenna being used in
the commercial sector--it has certainly been around to have gained
interest there, if deserved.

That is all folks ...

Regards,
JS