I would leave Vcc1 and Vbb(bias,I'm assuming?) connected to +5V,to avoid
frying the module.

Scott wrote:
I'm using a Mitsubishi M67749M in my 432 MHz beacon. The only datasheet
I can find at RF Parts shows maximum parameters, etc. There are no
charts showing output power versus such things as Vcc1, Vcc2, Vbb and
input power. Does anyone have the charts for this module?

If you do and can make an educated guess from looking at the various
charts as to what my output power will be?

I have it set up as follows:
Vcc1 = +5V
Vbb = +5V
Vcc2 = +13.6V
RF Input = 20 mW (+13 dBm)

My real question is will I get much output power with only +5V on Vcc1
or should I just tie it to +13.6V just as Vcc2?

THANKS!!

Scott
N0EDV