I had no trouble getting a SMPS transformer apart when I put it in a
sealed can with some MEK solvent and left it for 24 hours. I put some
scewed up wire mesh in the bottom of a small can to elevate the core,
so that it was only exposed to the vapour, and not immersed in the
MEK.
The E-cores separated with minimal force and with no damage after this
treatment, and the MEK did not affect the bobbin.
Make sure the can is properly sealed. I left the can outside to
minimise any exposure to the MEK fumes.
MikeN ZL1BNB
On Tue, 19 Aug 2003 19:57:02 +0100, "zindazenda"
wrote:
yes already found a problem..and thats i cant get the same core.
SO.....i have been led to believe that just about any toroid (that works at
HF) will work..has anybody wound a SMPS transformer on a toroid..input
voltage cir.
240v ac in rectified etc...28v out...
Since i dont intend to use the original pcb space is not a problem..
thanks simon g0zen
"Ian White, G3SEK" wrote in message
...
zindazenda wrote:
ok i have a pc psu or two now and have attempted to strip the transformer
but theres no way to take them apart without damaging the ferrite as they
seem to be glued!!so i am ordering some new un wound ones from rs...but
the
primary winding appears to be in 2 parts..one half on top(the outer
winding)
and the other on the bottom (inner.)i assume i will have to duplicate
this??
I'm not an expert on SMPS design, and espcecially not on the little
tricks that make the difference between just working and working well.
Obviously the extra complication of the split winding is there for a
reason, and my guess would be that it's to improve the high-frequency
performance by minimizing leakage inductance. Anyone else know for sure?
You may also be running into trouble by ordering un-wound cores, since
you don't know the specifications of the existing ones (permeability,
Bmax etc).
which makes winding the secondary a pain as its in the middle, and i am
sure
i wont get it right the first time,meaning stripping the primary down a
few
times..your thoughts??
also total winding of secondary 4+3+3+4 to give 12v..8+8 for 28v???5v 12v
not needed...
The basic turns ratios are OK... the details, I'm not so sure about.
Can anyone recommend a book on SMPS design that leads you all the way
from basic theory to real-life designs - including all those little
practical details that need to be right?
--
73 from Ian G3SEK 'In Practice' columnist for RadCom (RSGB)
Editor, 'The VHF/UHF DX Book'
http://www.ifwtech.co.uk/g3sek