Thread: Cutting non ferrous metals with a table saw
View Single Post
  #25   Report Post  
Old December 19th 08, 05:14 PM posted to rec.radio.amateur.homebrew
raypsi raypsi is offline
external usenet poster
  
First recorded activity by RadioBanter: Jul 2008
Posts: 242
Default Cutting non ferrous metals with a table saw
On Dec 18, 9:23*pm, "Dale Parfitt" wrote:
* Jimmie



Hey OM

did you looky at harbor freight tools?

I seen a twin blade circular saw $60 only

73 OM

n8zu

Commercially, we use a triple chip blade. The current blade is almost 10
years old and leaves a mirror finish on the aluminum cut.

Dale W4OP

Hey OM
If a twin blade 6.25 inch blade cuts like a 14 inch blade what's a
triple blade cut like?

And can you shave your face with that mirror?
That would make one heck of a disco ceiling mirror ball.

Twin blade is lifetime gaurantee.

73 OM
n8zu
Reply With QuoteReply With Quote