JP wrote:
According to the manual it reforms caps.That's my best answer.So where
is the drawing ro schematic of what you are talking about since I am
selling this one?

It does, but it's not a really good way to reform caps.

Here is a schematic, though you must have a fixed-width font to see it:

+-----)(--------+
| YOUR CAP |
| |
| o--------)-------+
| / \ | |
+--o/+ -\o----+ |
\ / |
\ / 1kv bridge |
o 1K ohm
| or more
| 1W or so
| 115vac .2a |
+uuuuuuuuuuuuuuuu+
==================
+mmmmmmmmmmm+-------------------/ |=
| on off ( |
+-------------------o/ o--------\_l= 117vac


The transformer output should be maybe half to 3/4 the rated voltage on the
capacitor. This is really just the front end of a power supply with an
enormously high value current limiting resistor so that the cap gets charged
up much more slowly than it normally would in a power supply application.

You can put a load shunt resistor across the cap if you want it to charge up
even more slowly and if you want to reduce the maximum voltage it charges up
to.

You can alternatively take the attitude that if a cap needs to be reformed
it should probably be replaced instead.
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."