Jim Kelley wrote:
So why do you have to go to all that trouble when you want to measure
traveling wave current, but not when you want to measure traveling wave
energy?

When one measures traveling wave energy, one
is measuring an average calculated scalar value
usually forward power minus reflected power or
RMS V*I in a dummy load resistor.

When one is measuring delay, one is measuring
instantaneous traveling wave phase in real time.
Trigger on the zero crossing of the input signal
and measure the delay until the output signal
crosses zero.

That delay measurement doesn't work for standing-
wave current because the zero-crossing on the
input and output occur virtually simultaneously,
i.e. there is no relative phase shift between
input and output or between any two points on a
1/4WL wire monopole.
--
73, Cecil, IEEE, OOTC, http://www.w5dxp.com