On Wed, 20 May 2009 13:01:07 -0500, Tom Ring
wrote:

Jeff Liebermann wrote:
connection were properly researched and documented. For example, it's
apparent that exposure to low frequency (HF) waves causes a marked
preference for noisy environments, the exact opposite effect is found
after exposure to high frequencies (VHF), where signal clarity is
preferred. This phenomenon and others should be investigated.

Obviously you've never been interested in weak signal V/U/SHF or EME.
These tend to lead to shack environmental noise levels approximating
WWII destroyer engine rooms. Another side effect is hearing CW in wind
noise when driving at over 60mph.

tom
K0TAR

I've done a little of that at VHF frequencies using various digital
modes. I was considering organizing a new certificate for "Worked all
Digital Modes", but every time I add a new mode to my computah,
someone invents yet another digital mode.
http://www.kb9ukd.com/digital/
http://www.wb8nut.com/digital.html
With weak signal digital modes, there's no way to actually hear the
signal as it's well below the noise floor. Waterfall displays work
nicely for copying extremely slow CW. It's a little like modern
astronomy. Most astronomers never look through the eyepiece of a
telescope these days.

Although I'm not a CW operator, when I was into Field Day, it took
several days for me to NOT listen for weak signals under the noise of
conversation, traffic, AM/FM radio noises, etc.

--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060 http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558