Noob questions?
D. Peter Maus wrote:
On 07/16/09 07:45, Tom Reinhardt wrote:
Over the years, I've used a portable Grundig radio to listen to both FM
and Shortwave broadcasts. I have relied on the antenna that came with
the radio, but this has, I'm sure, limited by listening capabilities.
Lately, I've been thinking about expanding my capacity: I'd like to have
more selection in my shortwave stations (this receiver, for instance,
doesn't support LSB or USB).
I've also noticed that a variety of options exist:
1) Tabletop shortwave units, combined with a quality indoor (or outdoor)
antenna;
2) Tabletop wide frequency receivers, again coupled with a quality
antenna; or,
3) Software-defined radios that essentially depend upon Windows machines
to work.
Of these, the last option doesn't appeal to me because I make a living
programming computers and would prefer a more "independent" medium. So,
that leaves me with questions about options 1 and 2.
If someone has a wide-spectrum receiver (capable of receiving SW, LW,
VHF, UHF, etc), could they also receive (digital) television signals,
allowing them to use this receiver as both a TV tuner and a radio?
Good question. I"m not aware of an ATSC adaptor for a stand alone
radio at this point. Although, that's not to say there isn't one.
AOR, and ICOM and JRC come to mind as manufacturers of wideband radios
for which NTSC adaptors were available, so you could, indeed watch TV on
your radio. Pretty cool. Worked decently, too. Took a little getting
used to, but fun.
Currently, ATSC portable portable TV's are just coming onto the
market, so it may be a while, yet before ATSC adaptors are available for
widebands. But I'm sure that's coming.
Because of where I live I cannot easily install an outdoor antenna, so
I'm considering several indoor units ---again, this might depend upon
whether I'm interested in SW or a wider frequency spectrum. Is this
feasible? In other words: do any of you have experience with these units
and do they work (of course I understand that you need a lot more
information --my location, etc., but these are general questions).
Indoor antennae are iffy at best in today's electronics rich home.
Even attic antenna can be pointless given the hash produced by monitors,
printers, TV sets, routers and digital cables strung around the house.
Outdoor antennae for HF radio listening can be large, require specific
grounding, and transmission line installation considerations. A really
good antenna will require some real estate, and a careful installation.
Alternatives include active antennae, which can be smaller, but more
sensitive to locally generated hash; loops which can be smaller, more
directional, but quieter than other actives; RF Systems Magnetic
Transfer Antennae, which can be larger than active loops like the
Wellbrook, but quiet, although they do require specific grounding. MTA's
are less sensitive, but with the lower noise floor, and considering that
most receivers have more than enough sensitivity to compensate, they can
be highly effective performers.
I use an MTA, myself. With good results.
Active loops and MTA's can be mounted outdoors but concealed, well.
They don't attract a lot of attention. Pricier than simpler outdoor
antennae, though.
For VHF and up, there are a variety of small, space efficient antennae
that can be equally well concealed. The discone is simple, quiet, omni
directional, and easy to install. It offers a 1-2 db gain over
isotropic. Commercial discones will typically reach to 1.3 Ghz. Some
more, some less.
There are also actives for VHF and UHF. These may tend to overload
with strong local signals, and strong local noise sources, so
installation location will be important. Relatively small, and
unobtrusive outdoors.
There are also a couple of HF-UHF actives. The same notations for HF
actives apply here.
With VHF and up, the higher the antenna, the longer the reach, so, you
need to keep that in mind. A passive antenna with height will generally
be more effective than an active in the attic. A passive directional and
a rotor will get you better S/N than an active omni.
For examples, check the Universal Radio website catalog, and the
Wellbrook website.
From there you can spring to any manufacturer whose products interest
you.
Thank you for your quick and thorough response. I think that I'll have a
look at that Wellbrook page, as well as Universal Radio, as you had
suggested. I think that at the end of the day, I need to determine if
I'm interested in SW alone, or if I want to attempt the wideband
receiver. Interestingly, I don't watch TV, my significant other does and
she hates dealing with the cable monopolies, so I though that this might
be a nice ancillary benefit.
Thank you, again ...
TomR
|