"Richard Clark" wrote in message
news
On Thu, 11 Feb 2010 11:32:35 -0000, "Barett"
wrote:
I have managed to borrow a Rigexpert AA-200. Is it possible to measure the
impedance with a AA-200 analyser and how would I do that?
Hi Barett,
Pass a single, short piece of wire through your core/bead. Connect it
to the analyzer. Read the Z. This will be enough to characterize
your ferrite material at any frequency within the range of the AA-200.
Now pass the wire (now longer) through your core/bead twice. Connect
it to the analyzer. Read the Z. You should observe four times the
earlier reading (you may have to perform complex math if the Z
contains substantial X).
Now pass the wire (now longer) through your core/bead three times.
Connect it to the analyzer. Read the Z. You should observe nine
times the earlier reading (you may have to perform complex math if the
Z contains substantial X).
Ferrite materials with one pass of wire will not exhibit a huge value
such as to lead to significant error, so as you progress through
successive passes of wire, you can be reasonably assured that the
square law will be observed within the capacity of the analyzer at low
HF frequencies (simply because the wire length being a significant
portion of a wavelength can confound measurements at higher
frequencies).
The single pass test will also help to select and compare previously
known and unknown ferrite materials.
73's
Richard Clark, KB7QHC
Nice info how to use the AA-200. Thanks
I read on the internet while reading through all the links that I should
make sure when ordering the 2631803802 #31 that they have been coated with a
hardener. Because a ferrite ring #31 that has not been treated with hardener
will break easily because the material will be too brittle.
I have been in touch with
http://gb.mouser.com and
http://uk.farnell.com
and they both say that there Fair-rite ring 2631803802 #31 does not come
treated with any hardener.
How important is it that they should be treated with hardener and if not
treated how easy are they to break?