On 12 abr, 23:03, "Irv Finkleman" wrote:
I am in the process of building a magnetic loop antenna. I have a roll of
1/2 inch
flexible copper tubing. I would like to increase the effective tubing size
by silver
soldering a second loop of equal size to the first loop -- point for point.
Would
it make any substantial difference if I just tacked the two together at a
number
of points, say every 45 degrees or so, or would it be better to solder them
together through the entire circumference?

The loop will be run HF QRP, with a maximum power of five watts,

Thanks in advance for any advice on this matter.

Irv VE6BP

Hello Irv,

As Roy also said, when they have the same size (diameter, shape and
length), some points are sufficient (electrically soldering just the
ends is sufficient). Limit the number soldering points to what is
good for mechanical stability.

Use copper or plastic mounting hardware. Resistive materials (steel,
stainless, etc) that are in the field (close to the copper tubing)
reduce efficiency.

Best regards and let your waves hit the sky,

wim
PA3DJS
www.tetech.nl
remove abc first in case of PM.