Perhaps you didn't see the earlier posts on the subject. The frequency
is 40Mhz (radio control band) and the tx output stage as it stands
puts out maximum power of 475mW with a 140 ohm resistor as load. I
only *need* 50mW ERP., however, so can stand to see quite a bit of
loss from an inefficient antenna. The antenna I will be using is a
telescopic whip - exactly the same set-up as you see with model
vehicle radio control transmitters- which is what it is, in fact.
It ain't rocket science.
Someone out there must know the radiation resistance of such a
telescopic whip (which has a ground plane of just around 16 square
inches contained within the remote control handset) and the best way
to couple it to a PA with a 140 ohm output impedance?

Google "electrically short"