View Single Post
  #4   Report Post  
Old December 22nd 03, 02:34 PM
G.Beat
 
Posts: n/a
Default

"Jim Adney" wrote in message
...
On Sun, 21 Dec 2003 22:24:27 GMT "G.Beat"
wrote:

Unfortunately, if a user or technician needs to replace the SW60

magnistat
switch or the line cord - the socket contacts (AMP Audio/Microphone
connector socket contact) needs to be removed from the new black plastic
insulator.


Is this for the female pins in the base? THose pins are the only
consistent source of trouble that I've ever had in over 25 years of
using the WTCP? series of Weller irons. Weller went thru several
generations of WTCP irons where some of those pins were crimped onto
tinned magnet wire. The crimps generally lose good contact within a
year and generate heat in the socket, which melts the connector body.

I LOVE these solder stations, but the very first thing I always do is
take those pins out and solder them.

The specific AMP Extraction tool for this procedure is part number

91136-1.
A "bobby pin" is suggested as an alternative in Weller's SW60 Magnistat
switch instructions.


I think I'll order one of the AMP extractors. I've always had a hard
time getting these apart gracefully. Thanks for the info.


Jim -

Yes, I was referring to the "Socket" connectors (AMP Part number: 207437-2
or 207437-3)
in the black plastic insulator [the pins (3) are on the Weller EC234 plug-in
heater assembly]

Here are the specific AMP document ID's / web page reference.

Audio/Microphone Connectors - Specification Or Standard (Application
Specification): 114-10011

AMP* EXTRACTION TOOL 91136-1 Specification Or Standard (Instruction Sheet
(U.S.): 408-7859

Catalog Page AUDIO/INSTRUMENT CONNECTORS: 82053_0794_2

http://ecommas.tycoelectronics.com/c.../DDEController

The tool is available from DigiKey and Mouser (I do not remember which one
had the AMP tool in stock) -
BUT it is NOT cheap (as I remember - over $ 25)

BTW, TYCO Electronics may have changed this original AMP part number -
since it took both Mouser and DigiKey a bit of time to cross reference the
part number.

Greg
w9gb