In article ,
says...

snippety

from my personal stuff purchased new. One example is a MGA Mitsubishi rear
projection TV that operated flawlessly for nearly 20 years of daily use.
Most of my test equipment comes from hamfests and is surplus after becoming
obsolete and non-operative in less than 20 years. That leads me to wonder
what the real story is behind tantalum capacitors. What do the experts have
to say?

The ONLY problems I've ever had with tantalums are whe

(1) The part was defective from the manufacturer.

(2) The voltage rating was consistently exceeded.

(3) The thing was installed backwards (reverse polarity).

I have no less than five Tektronix O-scopes here, all vintage
late-70's to mid-80's. This means not one of them is less than 20 years
old. They all use lots of tantalums, and they all work great, but then
again Tek was (in those days) proud of what they put out, and was most
definitely engineer-driven (which means at least a 20% 'fudge factor'
built into everything they made).

Tantalum caps are very stable and durable, but they are much more
costly than aluminum types. In consumer electronics, the manufacturers
will try to shave every penny they can off the cost of the design, often
contrary to good common (engineering) sense.

Such considerations are (usually) not so critical when it comes to
non-consumer stuff.

Keep the peace(es).

--
Dr. Anton Squeegee, Director, Dutch Surrealist Plumbing Institute
(Known to some as Bruce Lane, KC7GR)
kyrrin a/t bluefeathertech d-o=t c&o&m
Motorola Radio Programming & Service Available -
http://www.bluefeathertech.com/rf.html
"Quando Omni Flunkus Moritati" (Red Green)