"Paul Clay" wrote in message
...
What's the best way/tool to cut or drill holes 1/8 inch to 5/16 inch in
diameter in thin gauge aluminum (for inserting potentiometers and
phono, power jacks, etc.)? I've tried using just a power drill and
genernal purpose drill bits and the results have been sort of ragged
(the edges of the hole are ragged and the process of drilling creates a
depression surrounding the drilled hole).
Buy a good set of Greenlee punches - they'll cost a bundle but
there's no other good way to do it.
What's a good technique for labeling front panel controls on a piece of
homebrew gear? Are there self adhesive labels or decals that
stick/wear really well?
Go to a trophy shop and buy engraved phenolic plaque labels. They'll
cost ya about $2 each but look GOOD.
JOE
|