On Dec 31, 4:01*pm, John Ferrell wrote:
I am helping to install a 135 foot dipole on a hillside for HF
activity. The antenna will be at least 45 feet from the ground in any
direction. I can believe EZNEC so far as the effects of ground on
impedance. but I am at a loss when it comes to considering the
patterns on the various bands. The ridge is about 200 feet from the
antenna.

This is for a club member who recently upgraded to General Class.

Since the ridge is close to the same height and south of the antenna,
I am guessing that the computed charts will be a good representation
of the northern half of the antenna. NVIS should not change much. The
terrain may work as a reflector for over the pole operation. I am
afraid the antenna will be of little use to the south.

I expect we will eventually need to do the best we can with an antenna
on the top of the ridge. When the snow melts I will try to climb the
ridge for a look-see. It will likely be difficult to install due the
dense trees.

Any comments, advice, suggestions etc. are appreciated!
John Ferrell W8CCW

just put it up, hook up a tuner if the radio doesn't have one, and
have fun. you can spend all your time modeling trying to figure out
what it may look like, but if you are limited on how you can install
it you can't really control much anyway. an antenna laying on the
ground works much better than one that is only in your computer!