On Jan 4, 7:11*pm, Bob wrote:
Hello,

Have a new WinRadio receiver, and am a bit concerned about protecting
it's front end from possible damage due to ESD ElectroStatic Discharge,
effects, etc.

I do receiving only, and have an end-fed PAR antenna outside, feeding
the receiver by about a 30 foot run of coax from the antenna.
At the antenna, I have an ICE lightning protector, and a copper bar as a
ground point, there.

No idea if the ICE unit has a bleed resistor for dissipating any static
buildups.

Too advanced in years now to build anything myself incorporating Zeners,
Varistors, or whatever, so would like to find, if you folks feel it's
worth doing (?), a small box unit with bnc's on both end, that would
provide good and safe ESD protection that I would locate indoors right
next to the radio's input.

Any thoughts or suggestions ?
Brand, Model Number, or just forget as probably not needed ?

BTW: *Nice article on ESD at:
* * * *http://www.ce-mag.com/archive/01/Spring/Lee.html

Thanks,
Bob

unless the radio was shipped to you in a sealed esd protection bag and
had notes about what the esd handling requirements were, forget about
it and just plug it in and use it! ESD problems normally only apply
to bare integrated circuit leads and things connected to them like
pins on a card plugging into a computer motherboard. anything on an
external connector like where you would connect power and antennas
should already have sufficient protection for normal use.