amdx Inscribed thus:


wrote in message

...
On Feb 20, 11:14 am, "amdx" wrote:
wrote in message


...
On Feb 20, 10:20 am, "amdx" wrote:

Hi all,
I finished the amp that had the 5 Ghz transistor, I changed it to a
slower
one.
The objective of this amp is to cause minimal loading of the
circuit it is
measuring.
When I install the box cover the voltage gain drops by 7%, so I
think the
input capacitor
plate is being loaded by the cover.
The input capacitor plates can be seen here;

http://i395.photobucket.com/albums/p...mspaced5mm.jpg

The plates are 1 cm x 1 cm spaced 5 mm apart.

I have thoughts about rectangular plates 0.25 cm x 4 cm to get more
distance from the top cover, (and the bottom.)
Or a real gimmick cap where I twist a couple of 39 Gauge wires
together and
attach opposite ends to input and output.

Any ideas to minimize input capacitance to the box?

Here's the amp in

box.http://i395.photobucket.com/albums/p...erampinbox.jpg

This is the original circuit page with
schematic;http://www.crystal-radio.eu/enfetamp.htm
Thanks, Mike

PS, I was having trouble getting some close-up pictures, I grabbed
a magnifying glass and took some
pictures through that, works good.

.......................................

The old-tyme gimmick was two wires, twisted together. That would
contain the field better than your open plates.
Another alternative: you could surround your cap with a shield and
drive the shield from the FET source, bootstrapping it.
r

Hi James,
The twisted pair may be the easiest, but as a thought, if I took a
piece of coax and
removed the center conductor leaving just the shield, then inserted a
twisted pair as my capacitor.

That's too tight a box, and the dielectric screws things up--you'll be
making shunt caps to the shield.

I then connect the shield the FET source, Ok, I have never
bootstrapped before, but wouldn't I
then have a higher potential than desired, even a possibility of
oscillation?
..........................

Just the twisted gimmick itself is probably all you'll need. The
bootstrapping is lagniappe.

I tried a twisted pair of #26 wire and got way more capacitance then
I
wanted.
I ended up with just about 1/4" layed side by side as about equal to
0.3pf. When I put the cover on there was much less effect on the
signal than with the previously
used plate capacitor.
The side by side wire is not stable for long term use, so I'll find a
way to stablize it and
call this one a wrap. I'll try tying a low capacitance knot ;-)
I have two more boards and boxes, I'll build a bootstrapped version
for the next design.
I'll be back, I might try one with a gain of 1 and one with a gain
of
maybe 10.
Mikek

Try a glass cased diode with one end cut off so the case is empty. Use
the wire at one end for one connection, use a piece of thick wire
inside the tube for the other connection. Adjust for "C". Secure with
a drop of adhesive.

--
Best Regards:
Baron.