Paul,
The most obvious method would be to measure the open-circuit RF output
voltage, and then measure the output voltage with a known load. The output
impedance is a simple calculation of the ratio of the voltages.
However, depending on the vintage and quality of the generator, the
impedance is likely to change with frequency, and possibly even with output
level. For source-impedance-sensitive measurements, it's generally a good
idea to put a small amount of fixed resistive attenuation at the output
(6-10 dB) in order to "fix" the impedance.

Joe
W3JDR

"Paul Burridge" wrote in message
...
Hi,

I have a spare RF signal generator that has an unmarked output from a
type of socket I've never seen before. What's the simplest way of
establishing its output impedance? I've had a few ideas but no doubt
someone out there will know of something better, since I always seem
to end up making unnecessary work for myself.
Any suggestions?

p.
--

The BBC: licenced at public expense to spread lies.