View Single Post
  #103   Report Post  
Old February 11th 12, 01:57 AM posted to sci.electronics.repair,rec.radio.amateur.antenna,sci.electronics.design
tom tom is offline
external usenet poster
 
First recorded activity by RadioBanter: May 2009
Posts: 660
Default Increasing Cable TV signal strength

On 2/10/2012 7:47 PM, Michael A. Terrell wrote:

Still easier than having to use blasting caps to find the ends of a
broken conduit under the finished concrete floor in a new RADAR site.
An old fish tape& blasting cap pushed as far as it would go and
BOOM!!!. Then repeat for the other end. Then they used a jackhammer to
break out the concrete between the huge floor divots to install new
conduit. The electrical contractor had failed to tie the conduit to the
rebar& wire mesh before the pour.

Or driving ground rods through permafrost in Alaska. We drove 60' of
rod and used three tanks of Acetylene to heat the rod to get it through
the ice layer outside a military radio& TV station at Ft. Greely.


You've got me beat.

I am glad I didn't have to use blasting caps as TDR. But it does sound
kind of fun if you didn't have delivery pressure on top of it.

Sounds like good work. But not up the Giant Rat's standards, I'm sure.

Interesting that he portrays himself as young and uses that reference.
Very curious. Maybe he's old and a failure and not young and a failure
as he claims.

tom
K0TAR