Homebrew Coil Form Factor
On Saturday, October 5, 2013 7:44:30 PM UTC-5, Jeff Liebermann wrote:
On Sat, 05 Oct 2013 15:24:01 -0500, John S
wrote:
The microwave oven test is not very useful. The microwave will test
whatever at about 2450MHz. I doubt he is trying to make a loading coil
for anything near that frequency.
Actually, it's very useful. In my admittedly limited experience,
anything that survives the microwave oven test, will usually work
nicely at HF frequencies. Those that get warm in the oven, might
work ok. Those that melt, burn or explode, will probably not work
very well at HF. While testing at 1000 times the frequency, and 30
times the power, might be considered overkill, it does yield some
useful information.
I had always heard that if one were to use PVC, the gray type was
the best vs the white. I've used gray PVC for mobile whip loading
coils for years and never really noticed any real problems.
But, I do not run high power, and 100w is the max I run.
I've always had good results with the antennas, and noticed no
noticeable performance loss vs say an open type bug catcher coil.
There may be some, but it's small enough not to be a problem.
When I first started using the gray PVC, I stuck it in the
microwave with a glass of water, and it did not get warm at all.
I have heard the white PVC can be more of a problem.
|