On 8/23/2014 8:31 PM, Barry OGrady wrote:
On Sat, 23 Aug 2014 23:34:54 +0100, supremme
wrote:

I recently purchased a swan 500c, according to the seller in good
condition, but had not the power supply. I have a Henry tempo of an old
one (yaesu ft200) supports this power supply with swan 500c? I have been
looking for the characteristics and voltages seem to be correct, but I
have no info intensities. I measured the voltages on the power supply of
one tempo a -118, 352, 670 vdc. in the voltage of 300VDC in the swan
500c what is 325vdc max in one tempo I have 352, with load, when they
should be 300VDC. not if it is a problem of the source of one tempo or
so. my question is? I can put the swan 500c in power supply one tempo?
thank you

You should rewrite this when you are sober.
It doesn't make sense as it is.






--
supremme


You should figure out English is not his first language. This is an
international newsgroup, after all.

The question is perfectly clear; I just don't have enough knowledge of
the Swap 500C to know if the higher voltage will do any damage or not.

--
==================
Remove the "x" from my email address
Jerry, AI0K

==================