On 11/5/2014 1:29 PM, rickman wrote:
On 11/4/2014 9:42 PM, Jerry Stuckle wrote:
On 11/4/2014 6:29 PM, rickman wrote:
I am working on a project for receiving a very narrow bandwidth signal
at 60 kHz. One of the design goals is to keep the power consumption to
an absolute minimum. I'm trying to figure out how to run a
pre-amplifier on less than 100 uW. So far I have found nothing. Any
suggestions?


I agree with Jim. We need many more specifics to provide a meaningful
answer. There are a lot of micropower opamps out there now, but the
devil is in the details.

I've only found one detail that is giving me the devil. That is the
bandwidth. The signal is 60 kHz. I can't think of any other issues I
would have with any amp capable of amplifying this signal with a low
power level. What more info do you feel is needed? Can you ask
questions? Better yet, just point me to any amp that will meet my two
stated requirements!


The other posts you made had the info - things like impedance and gain
are important, as is frequency of operation (but we already know that).

A couple of things to consider, however. The higher the impedance, the
more susceptible it will be to ambient noise pickup. You're starting
with a very small signal and may need to add shielding to limit external
noise.

The other problem is you're asking for low impedance output. Low
impedance limits noise pickup, but increases current drain. So how low
of an impedance do you want?

There are op amps with very high (in the gigaohm range) input impedance
and pretty low quiescent current drain. How much it draws during use
will be greatly dependent on the output current required, which
obviously depends on output voltage and impedance.

I don't have time right now, but later today I'll look through some of
my data sheets on op amps to see what I can find.

--
==================
Remove the "x" from my email address
Jerry, AI0K

==================