=2D----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

I am currently using a West Mountain RIGrunner with the big leads
connected to a sizable power supply. I am curious as to the best way
to attach my deep-cycle batteries to this system. The goal is to have
a station which can run uninterrupted through a power outage or
battery switching, and whose connected batteries are kept charged
continuously.

The ideal solution here seems to be two power panels -- one for power
sources, and one for power consumers. A nice thick set of wires will
connect the source power panel to the DC IN on the consumer power
panel. My power supply can be connected to the source power panel,
but I'm not sure what I should do about the batteries.

Is it as easy as connecting the batteries directly to the source power
panel? I seem to recall a posting about using a relay to protect
against low voltage conditions on the batteries -- I'll try to find it
to see how to apply it to my situation.

Will I need to modify the power supply so that it doesn't get
zorched by the batteries when commercial power fails? There was an
old ARRL article series on power supplies, and I think they mentioned
using a diode to prevent shorting something out.

Will my equipment be damaged if I add or remove batteries to the
source power panel? Will it matter if commercial AC is on or not?

Jack.
=2D --=20
Jack Twilley
jmt at twilley dot org
http colon slash slash www dot twilley dot org slash tilde jmt slash
=2D----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.3 (FreeBSD)

iD8DBQE/tTvDGPFSfAB/ezgRAnJEAKDUwonvr8ileEpJXQhsRW8RTebbYACeKnbi
JCnG0NfBXM38a4YuevAx8SE=3D
=3D+rWT
=2D----END PGP SIGNATURE-----