"MR NO SPAM" wrote in message
...
I don't have a manual for it but a lot of radios have a pot labeled tone
volume. Take a look. I'm confused though, your statement must have a
typo..
IF the repeater doesn't have CTCSS / PL access on it, why worry about the
tone? There should be a switch to disable it. MNS.

This person is in Europe... the standard for
a long time was to open the repeater rx
via a short 1750Hz burst at the beginning
of your tx. Probably still a lot of those
machines around.

For the Original Poster: Do you have a
copy of the docs? I found this link:

http://www.xs4all.nl/~pa0nhc/Modific...707/DevAdj.htm

it explains how to set your deviation.
You could always talk softer, and
increase your overall deviation, that
might work, and it might not. There
might be a tone deviation in that menu
the link describes... that would explain
a lot, since you've changed to Euro
standards but might not have changed
the tone deviation from low (use for
PL/CTCSS in USA) to high (used
for burst tone access). Good luck!
__
Steve
KI5YG
..