Hello,
I need some help in figuring out how to properly use a Spec. Analyzer.
I have done several hours of research online now, and have somewhat of
an idea of what I am doing, but I just can't get down one piece of the
puzzle. In my line of work, we use simple devices that give us the
noise floor level in dB. I (stupidly) expected to be able to get this
same information easily out of a SA. As you may have guessed by now, I
ran into a problem when switching the RBW value. After much... much
reading, I fully understand *WHY* it changes (Filters increasing in
size cause a greater internal noise level, etc.) but I can't figure
the best way to get a "base" noise level reading. And as much as I
would like to fully understand the theory, what I really need is a few
more examples... IE: If you are looking a 100 MHz span and your RBW is
1MHz simply ___Fill in the Blank____ to find the base noise floor. To
further explain what I am trying to do, we are setting up a link that
requires a SNR of at least 6dB... I need to get the noise floor level
to compare with my projected signal strength for this link.

Please be nice... This is my first post grin

Thank you! Thank you!

Bill B. - N1SNI