RadioBanter - View Single Post

Ralph Mowery · September 11th 18, 09:49 PM posted to rec.radio.amateur.equipment

In article ,
says...

Does one also crimp the inner, for it seems far
too tiny to survive such physical action?

Also, with general purpose crimping tools, when
fully open, is there sufficient room for the
assembled BNC plug to pass back through the opening?

(Visions of a double-ended BNC lead with the crimping
tool forever doomed to dangle from the middle :-) )

(Question originally posed in uk.radio.amateur but
no replies received)

Some bnc crimp and some solder the center pin.

The criimping tool for the furrel opens up wide enough to get the tool
off.

Here is one of the many youtube videos on crimping a bnc.

https://www.youtube.com/watch?v=ktQVwfo-s9w