"John" wrote in message
...


Dan/W4NTI wrote:
"GeorgeF" wrote in message
ink.net...

I’m experiencing some strong interference across the 6 meter band which
I believe is coming from a local (within 40 miles) TV channel 2. Where
can I get a filter to deal with this? Is there a low pass filter with
a cutoff at 54 MHz? I only work SSB and CW on 6 so I’m only interested
in the lower portion of the band, if I cut off 52 MHz and above that
would be fine by me…..

George


Possibly you could notch it out. Look around for a ARRL handbook and
check
out the subject.

Sometimes a hunk of coax with a trim cap can do the trick. Or you may
have
to get more elaborate. Start out simple. Again look it up in a ARRL
handbook. I don't know about the new ones, since its all appliance ops
now
a days.

Dan/W4NTI


There were commercial low pass filters on the market (Drake?) with a cut
off of
about 52MHz. Ratings were 1KW in the HF bands but only 100W on 6. Worked
well on 6 between the exciter and amp. I would suggest looking for a
surplus unit or building yourself as others have suggested.
73, John


"IF" I read the OP correctly, HE is the one being interfered with. A LOW
pass isn't going to cure anything. That is for TRANSMIT on his end.. He
needs to "notch" out the Channel 2 signal by whatever means from his
receiver - when in the receive mode. I'm thinking a T on the back of the set
with a stub - open or shorted, but may be tricky so as not to interfere with
the rest of the receiver frequencies or transmit. A little experimentation
here can go a ways.

TBA