Hi,

I built a Super J-Pole like this one:

http://www.nemr.net/~aschmitz/antennas/jpolecalc.html

For 300 watts, VHF frequencies. With i believe 6 turns of 4"
diameter
inductive loops in the coax (RG-213), just at the base of the antenna.

Problem was, the antenna had an intermittant problem, which turned
out
to be the dielectric foam material MELTING right at the inductive
loops in
the coax. I tore off the outer jacket, and the foam was melting and
oozing
past the outer braid, really nasty...so that the inner conductor was
intermittantly touching the outer braid, most likely.

A real hair-puller, because the super-J looked fine when i took it
down.

Can i get away without using the inductive loops? They are
supposed to be there to prevent the current from going down the
outside braid, right? So
that you don't have radiation along the coax?

Or perhaps i can make fewer turns, or larger diameter loops? So
that the
impedance discontinuity is less severe at this point?

Knowledgable advice much appreciated.


Slick