Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
Balance woun't be the problem, Doug. The problem is that over that long a
run, the feedline will radiate, and become a major part of the antenna system. The other problem is keeping the feedline far enough away from eveyerything else along that run, that could interact with it. For such a long run with a feeder at ground-level, you might want to investigate low-loss coax... - Mike KI6PR El Rancho R.F., CA "DOUGLAS SNOWDEN" wrote I am planning on putting up a ground mounted vertical for 40 and 80 meters. Somewhere between 70-90 ft tall and insulated from the ground. The antenna will be about 275 ft from the shack. My question: is it advisable to feed a vertical with open wire feeder? I am thinking it would work ok either directly or through a balun on one or each end of the feedline, but how does one keep the RF from the radiator from unbalancing the line? Or would it just tend to hit both sides of the line and not upset the balance? Doug, N4IJ |
#2
![]() |
|||
|
|||
![]()
Mikey wrote:
Balance woun't be the problem, Doug. The problem is that over that long a run, the feedline will radiate, and become a major part of the antenna system. The reason that the feedline radiates *is* unbalanced currents. If the currents can be balanced, the feedline will not radiate appreciably assuming good engineering practices are followed. -- 73, Cecil, W5DXP |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Inverted ground plane antenna: compared with normal GP and low dipole. | Antenna | |||
Mobile Ant L match ? | Antenna | |||
Poor quality low + High TV channels? How much dB in Preamp? | Antenna | |||
QST Article: An Easy to Build, Dual-Band Collinear Antenna | Antenna |