Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Old March 31st 07, 03:17 PM posted to rec.radio.amateur.antenna
external usenet poster
 
First recorded activity by RadioBanter: Jul 2006
Posts: 625
Default analysis and hypothesis question?

On Mar 31, 7:22 am, "Dave" wrote:
"dansawyeror" wrote in message

...



All,


This is a real world "what is going on" question. The antenna is a
'screwdriver' on a 3 foot stand in the back yard. The earth ground is
normal loam, the original soil was forest. The feed cable is about 130
feet 50 ohm coax that measures to be in good shape. The ground system is 8
wire radials between 30 and 60 feet in length.


The measurement tool is an HP 8407a network analyzer and an HP 8601a sweep
generator. The frequencies of interest are from 3.5 to 4 MHz. As the
antenna is moved from resonance at 3.5 MHz to 4 MHz the return shows a
marked difference. It varies between -24 db and -50 db. The pattern is
irregular, however it is repeatable.


The antenna design is a coil that moves up or down across copper fingers.
As the coil moves those fingers contact more or less of the coil and
change the impedance.


What could cause the variation in return across a relatively narrow band.
A return of -24db is relatively small, an impedance very close to 50 Ohms
and an SWR about 1.135. A return of -50 db is less then 1.01 SWR and
represents a small change in Z, however a change non the less.


I can think of three potential causes for this change:


1. variations in the coil change Q


2. variations is the finger to coil connection change R


3. variations in the ground radials.


Are there others?


Thanks - Dan


the real important thing though is that the match is near perfect at either
1.135:1 or 1.01:1, so stop playing around and put some power to that sucker
and make some contacts! remember, 'too low an swr can kill you'! or at
least keep you off the air for as long as you are tweaking it.


My experience with a screwdriver antenna is that the bandwidth vs vswr
is not as good as he is showing. My bet is that the ground is acting
pretty much like a dummy load making the SWR look real good. He could
probably use a good ground system before he tries talking . If I were
using a screw driver antenna as a base antenna I would consider
seriously increasing the length of the radiator.

Jimmie

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
9 m Monopole Analysis Frank's Antenna 10 August 25th 06 08:58 PM
coverage analysis using TIREM MRW Antenna 2 June 10th 06 01:02 PM
Vector network analysis question [email protected] Homebrew 24 May 26th 06 04:27 AM
Need further info on network analysis terms... [email protected] Homebrew 17 May 10th 06 10:47 PM
Antenna analysis Jack Twilley Antenna 28 March 18th 04 12:17 AM


All times are GMT +1. The time now is 04:36 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017