Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
On 24 Apr, 22:46, Owen Duffy wrote:
"Jimmie D" wrote : I want to make some fiberglass antenna parts that would probably most easily be make by turning fiberglass rod in my lathe. Ive never done this before and was wonder how rough fiberglass would be on the tools/lathe. I have a piece of 1- 1/4 inch fiberglass rod I want to turn down to fit the inside diameter of a piece of 1-1/4 inch tubing. Im thinking get a piece of square stock and make a diposable cutting tool for this. The only tools that I have used to cut GRP have been carbide tools. You need to consider the dust hazard. Owen You sure do. I didn't notice it at first until a ray of sunshine came thru the window and it could be seen swirling in the air. Art |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Could I be turning gay? | Policy | |||
Could I be turning gay? | General | |||
I am turning the asylum over to the inmates | Shortwave | |||
This place is turning into a sewer | CB | |||
Help! IC-706MKIIg has started turning itself off! | Equipment |