![]() |
On Fri, 13 Feb 2004 15:49:59 -0500, "John Passaneau"
wrote: I used to work with a 50KW induction heater that ran at about 500KHz and it would heat my belt buckle but not me, at least not directly. Hi John, Sitting directly on top of the international maritime distress frequency? 73's Richard Clark, KB7QHC |
OK on the comments, it was my point that exposure to almost any reasonable
level of RF from antennas is not harmfull. If anything it is beneficial. Microwaves are different story, yes, eyes and nuts are most sensitive. But the recent bugaboo from FCC and ARRL about RF exposure levels is nuts and another scary crap. Magnetothermia is RF heating with around 27 MHz and statically shielded loop. It allows to focus the energy into body parts and it was found to heal fractures by 60%, asthma clogging, cold, painfull joints, cook cancer tumors, etc. So enjoy your RF exposure, get daily dose of sunshine and you will live long and be sharp. 73 Yuri, K3BU |
In article ,
Yuri Blanarovich wrote: OK on the comments, it was my point that exposure to almost any reasonable level of RF from antennas is not harmfull. If anything it is beneficial. Microwaves are different story, yes, eyes and nuts are most sensitive. But the recent bugaboo from FCC and ARRL about RF exposure levels is nuts and another scary crap. One thing I might be concerned about, in running a long-wire into the house, is the possible presence of high RF voltages on the inside end of the wire. If the wire happens to be near anti-resonance on a particular band, and it's successfully tuned using an ATU or step-up transformer, then there could be some very high voltages present. There might be similar issues with the artificial-ground system or indoor counterpoise. Running 100 watts of RF into the heating pipes, household ground wire, etc. seems like maybe not the best of ideas. RF burns hurt, and can be dangerous. Even a 100-watt barefoot system packs quite a bit of punch at the high-voltage points on the antenna system. A system of the sort that the OP plans to use, deserves careful planning and installation to make sure that the high-voltage points are safely insulated, and protected against casual and accidental contact by the operator and by anyone else. Otherwise, somebody might get "bitten". As to the FCC regulations re RF exposure, and the ARRL's publicizing of them, I'd make the following two comments: [1] Like 'em or not, believe in 'em or not, they have the force of law. They're part of what we agreed to comply with, when we applied for our licenses. [2] From what I've heard, the setup that the OP is considering using is perhaps more likely to generate RFI/TVI than a system using a balanced antenna located well clear of the building. Hence, it's probably more likely to generate complaints from neighbors and from the landlord, and questions about whether it's safe. It can probably help to diffuse such complaints (and perhaps avoid a "shut it down or lose your lease" warning from the landlord) if you can demonstrate that the calculated RF exposure levels to everyone concerned are below the FCC's published limits. -- Dave Platt AE6EO Hosting the Jade Warrior home page: http://www.radagast.org/jade-warrior I do _not_ wish to receive unsolicited commercial email, and I will boycott any company which has the gall to send me such ads! |
All times are GMT +1. The time now is 03:19 AM. |
Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
RadioBanter.com