About Us

Ian Jackson[_2_]

In message . com,
JIMMIE writes

Roy Lewallen wrote:
JIMMIE wrote:

Try some 3mil Teflon, Teflon has a very high capacitive coefficent.

I'm afraid you're misinformed. The dielectric constant of PTFE Teflon is
2.1, or just about twice that of air. Quite a few plastics are higher
(e.g. Mylar at 3.2 and PVC around 3.5), and many materials, such as
those used for capacitors, have dielectric constants that are a lot
higher (e.g., barium titanate at 1500 - 2000). Of course, a lot of the
latter aren't physically suited for this application. A long time ago, I
had trouble with microstrip line dispersion in a high speed delay line
compensation network design. So I chose Teflon for the substrate
material because of its *low* dielectric constant. The previous design
was on an alumina substrate having a dielectric constant of about 10.

The capacitance of two parallel plates is directly proportional to the
dielectric constant and the plate surface area, and inversely
proportional to the plate spacing. So putting 0.1 inch of Teflon between
the plates gives you the same capacitance as putting the plates 0.05
inch apart with air between.

This isn't to say that Teflon might not be a good choice. It's a very
low loss material, and chemically very inert. It's soft so won't
scratch, but it's slippery which might be a disadvantage. It's also
subject to cold flow, but there probably won't be enough pressure for
that to be a problem.

Roy Lewallen, W7EL

It was a joke. I actually tried it on my wifes car, she wouldnt let me
drill a hole. The antenna stayed on about 3 minutes, just long enough
for her to get out of the neighborhood and get up to about 45MPH, then
it slid off and scratched the side of her car.Slipperiness is a BIG
disadvantage.

Use RUBBER.
--
Ian

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Antenna Simulation Parameters and Folded Dipole Antenna Question...	RHF	Antenna	3	January 23rd 07 03:43 PM
Question is 'it' a Longwire {Random Wire} Antenna -or- Inverted "L" Antenna ?	RHF	Shortwave	5	November 6th 05 04:52 AM
Antenna Question	Chris	CB	0	August 5th 04 06:39 PM
antenna question	Sanjaya	Shortwave	32	July 20th 04 08:16 AM
APS-13 Antenna question	DJboutit2	Antenna	0	October 15th 03 12:50 AM

Menu

About Us