Richard Clark wrote:
Sorry, your 20 questions are up.

OK, so you will not adequately support your claim for measurement. On
the basis of what has been revealed, however, it shows absolutely no
evidence of transmission line behavior.

If you want evidence of transmission line behavior
look at the EZNEC files for:

http://www.w5dxp.com/travstnd.gif

One file is a coil terminated in its characteristic
impedance. The other is the same coil unterminated.

Based on your questions, an ordinary prudent man would
assume that you are just wasting my time. Next thing
is that you will be ragging on me for the number of
postings I had to make in answering your questions.

If you want transmission line behavior evidence in
coils, look at Corum's Figure 2 in section III of
his paper.
--
73, Cecil http://www.w5dxp.com

On Thu, 06 Dec 2007 21:22:09 GMT, Cecil Moore
wrote:

Based on your questions, an ordinary prudent man would
assume that you are just wasting my time. Next thing
is that you will be ragging on me for the number of
postings I had to make in answering your questions.

Well, you didn't answer them all did you? And you didn't really have
anything to show short of those answers until I asked for them, did
you? And you certainly don't have a page of published RESULTs such as
Tom has where the settings and readings are all readily visible and
available, do you?

Of course this laborious, tedious, and painstaking. This is called
the work of science and engineering - or you could just go back to
mooching for validation, the correspondence you commit to that in a
hour far exceeds responding to these few questions over several days.

So, what voltage magnitudes were presented to the inputs of your
scope? or should I consider your silence to a rather ordinary question
as you having hit the limit of your technical depth?

Richard Clark wrote:
On Thu, 06 Dec 2007 21:22:09 GMT, Cecil Moore
wrote:

Based on your questions, an ordinary prudent man would
assume that you are just wasting my time. Next thing
is that you will be ragging on me for the number of
postings I had to make in answering your questions.

Well, you didn't answer them all did you?

I answered them until the total number of them
started approaching infinity when your motive
became clear.
--
73, Cecil http://www.w5dxp.com

So, what voltage magnitudes were presented to the inputs of your
scope?