I have a white fiberglass top loaded antenna that is 48 inches long.

At the bottom of the antenna where the metal part screws onto the L bracket
aluminum mounting base is imprinted 'wondershaft'.

It is toploaded because the top 15 inches is thicker and I assume there is a
coil of wire under the white fiberglass covering.
It uses a Pl259 coax connector mount on the base for the coax cable.

Does anyone know if this is a marine CB antenna or would it be a marine VHF
antenna or how to tell the difference?
Thanks for any info.

Scott;

What you have there is a CB antenna. You can tell from the loading coil
at the top of the stick. A VHF marine antenna will not have any coils as
the 48" length is sufficent for a half wave vertical dipole.

Dave WD9BDZ

Scott Downey wrote:
I have a white fiberglass top loaded antenna that is 48 inches long.

At the bottom of the antenna where the metal part screws onto the L bracket
aluminum mounting base is imprinted 'wondershaft'.

It is toploaded because the top 15 inches is thicker and I assume there is a
coil of wire under the white fiberglass covering.
It uses a Pl259 coax connector mount on the base for the coax cable.

Does anyone know if this is a marine CB antenna or would it be a marine VHF
antenna or how to tell the difference?
Thanks for any info.

Thank you.
I was hoping toward CB. I am going to add a CB radio to my boat. I already
have a VHF radio.

I have a SWR meter. Will the length of the coax have an effect on the
tuning? I would like to have a run from the top of the flybridge to cabin of
perhaps around 20 feet.

"David G. Nagel" wrote in message
...
Scott;

What you have there is a CB antenna. You can tell from the loading coil
at the top of the stick. A VHF marine antenna will not have any coils as
the 48" length is sufficent for a half wave vertical dipole.

Dave WD9BDZ

Scott Downey wrote:
I have a white fiberglass top loaded antenna that is 48 inches long.

At the bottom of the antenna where the metal part screws onto the L
bracket
aluminum mounting base is imprinted 'wondershaft'.

It is toploaded because the top 15 inches is thicker and I assume there
is a
coil of wire under the white fiberglass covering.
It uses a Pl259 coax connector mount on the base for the coax cable.

Does anyone know if this is a marine CB antenna or would it be a marine
VHF
antenna or how to tell the difference?
Thanks for any info.

Scott Downey wrote:
I have a SWR meter. Will the length of the coax have an effect on the
tuning? I would like to have a run from the top of the flybridge to cabin of
perhaps around 20 feet.

Is the (metal?) flybridge your ground plane?
--
73, Cecil http://www.qsl.net/w5dxp



-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----

The boat is mostly wood and fiberglass, only metal is railings.


"Cecil Moore" wrote in message
...
Scott Downey wrote:
I have a SWR meter. Will the length of the coax have an effect on the
tuning? I would like to have a run from the top of the flybridge to
cabin of
perhaps around 20 feet.

Is the (metal?) flybridge your ground plane?
--
73, Cecil http://www.qsl.net/w5dxp



-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----

Scott Downey wrote:
The boat is mostly wood and fiberglass, only metal is railings.

To what is the coax shield going to be tied? If that antenna is
an electrical 1/4 wavelength, where's the ground plane?
--
73, Cecil http://www.qsl.net/w5dxp



-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----

There is a large stainless metal ground plate with molded in tubes (
increased surface area) attached to the keel.
About 4 feet by 2 feet. I was told years ago these plates may have been used
for AM ground plates??? when using an AM transmitter or perhaps for
lightening protection. The boat was built in 1970. All the electronics are
grounded and this is also included in the ground.

"Cecil Moore" wrote in message
...
Scott Downey wrote:
I have a SWR meter. Will the length of the coax have an effect on the
tuning? I would like to have a run from the top of the flybridge to
cabin of
perhaps around 20 feet.

Is the (metal?) flybridge your ground plane?
--
73, Cecil http://www.qsl.net/w5dxp



-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----

Scott Downey wrote in message
...
There is a large stainless metal ground plate with molded in tubes (
increased surface area) attached to the keel.
About 4 feet by 2 feet. I was told years ago these plates may have been
used
for AM ground plates??? when using an AM transmitter or perhaps for
lightening protection. The boat was built in 1970. All the electronics
are
grounded and this is also included in the ground.


Probably would work O.K. for the 2-3 Mhz HF marine band and a mast supported
antenna wire, but you'll need a "local" groundplane for the 27Mhz antenna to
attach the coax shield to, as was previously questioned.