Home |
Search |
Today's Posts |
#5
![]() |
|||
|
|||
![]()
Barrett wrote:
Just went out to get things ready to try the Ariel's out tomorrow and it occurred to me that the 20ft pole is resting on the patio. To make this work, would I need to lift the pole off the floor and would 1ft be enough? Depends on whether the patio is conductive or not. Probably best to rest the base on an insulator. Also be aware that, at 100 watts, there will be hundreds, if not thousands of volts present at the base of the pole. I once keyed down while a cat was standing on one of my radials. Not sure where it went, but it might have gone into orbit. Have you considered sleeving the pole inside PVC pipe for safety reasons? -- 73, Cecil http://www.w5dxp.com |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
500MHz wideband filter design | Homebrew | |||
FA: 12 Receiver Multicoupler 1-500mHz | Boatanchors | |||
FA Stridesberg Multicoupler 100Khz to 500mhz | Swap | |||
Any mobiles with RX in 500mhz? | Equipment | |||
Any mobiles with RX in 500mhz? | Equipment |