On 5/31/2011 11:59 PM, K7ITM wrote:
On May 31, 3:46 pm, John wrote:
On 5/31/2011 5:40 PM, John S wrote:
As an aside, I found it time consuming to adjust angles and repeat the
source impedance test in EZNEC. So, I created an Excel spreadsheet where
I could simply input the perimeter, the acute angle, height above
ground, wire gauges, and number of segments and wrote a short VBA to
gather the spreadsheet results and create an EZNEC importable file.

Man, what a time saver.

73,
John

That sounds like something that would be valuable to others, too,
John. You might think about making it available...


It is so narrowly focused on the rhombus that I doubt it would be useful
to anybody else. But, it is available to anybody who wants it.

John