Home |
Search |
Today's Posts |
#15
![]() |
|||
|
|||
![]()
"Henry Kolesnik" wrote in message ...
I'm probably not the only one that is getting an adequate fill of facts, opinions and quotes. I have only one request. Does anyone have verifiable and repeatable evidence that a properly tuned pi network final amplifier without a tuner does or does not dissipate power when there are reflections? If they do can they please direct us to the source or give us an easliy understandable write up. If you read Chapter 13, "RF Power Amplifiers and Projects", in the 2004 ARRL Handbook, there are pages and pages of discussion of matching plate or transistor output impedances to 50 ohms output and not once do they ever refer to output networks dissipating or reflecting reflected power. Not once. It's always a matter of simply matching one impedance to another to provide the highest power output consistent with required linearity, while staying within the amplifiying device's ratings. Transmission lines have reflections; output matching networks and tuners don't. The reflections on transmission lines don't make it past the end of the transmission line -- that's where the reflections take place. Beyond the end of the transmission line, the reflections are seen as mere impedances created by standing waves, which are created by reflections, assuming mismatch. Al |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Rho = (Zload-Zo*)/(Zload+Zo), for complex Zo | Antenna | |||
Derivation of the Reflection Coefficient? | Antenna | |||
Length of Coax Affecting Incident Power to Meter? | Antenna |