LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #8   Report Post  
Old July 19th 04, 07:05 PM
Jack Painter
 
Posts: n/a
Default

"Bob Miller" wrote

For my general station ground, I have a copper pipe that goes down
about one foot -- then hits rock or limestone or whatever.

I'd like to enhance the pipe with a few buried radials. I happen to
have a 500' roll of 14-guage stranded *insulated* copper wire. Will
the insulation keep the wire from becoming "one with the dirt"?

Or should I go buy some bare solid copper wire?
---
and then Bob added:

Question -- is there a problem in using a safety ground as an rf
ground, too? If I connected 10x50-ft bare, buried radials to my little
pipe, and used it as a safety ground for the station, and also as a
ground to work an inverted "L" against, would that be a problem, or
should I have separate ground points?
--

Hi Bob, can you be more clear on what you meant by "general station ground"?

Since you're in thunderstorm country it could be you mean a lightning
protection ground. But you also mention safety ground and RF ground so it
appears you have multiple requirements here.

Conductor choices vary according to the function of the system so it is
difficult to generalize about stranded v. solid wire until you can be more
specific in your requirements. In some cases neither kind of wire is
appropriate, with wide/heavy gage copper strap being the best choice.

However many purposes your ground system fulfills, and from however many
places it connects to ground rods, one standard always applies: you must
always bond all of your earth-references (ground rods) to your station
equipment AND the main entrance ground of utility wires coming into your
home. Preferably that station single point ground and the Utility single
point ground are the same place. Unfortunately few of us are so lucky as to
be able to locate our station right at the main Utility service entrance.
When the two are far apart that creates problems. With a lot of help from
this group, and professional engineer review, I completed a station
grounding and lightning protection system that accounted for those problems.
The complete site construction plans are listed at:
http://members.cox.net/pc-usa/station/grounding.htm

Hope this helps,

Jack Painter
Virginia Beach, VA


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Inverted ground plane antenna: compared with normal GP and low dipole. Serge Stroobandt, ON4BAA Antenna 8 February 24th 11 10:22 PM
Adding lengths to bare wire antenna? Ken Antenna 8 May 3rd 04 03:03 PM
QST Article: An Easy to Build, Dual-Band Collinear Antenna Serge Stroobandt, ON4BAA Antenna 12 October 16th 03 07:44 PM


All times are GMT +1. The time now is 06:17 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 RadioBanter.
The comments are property of their posters.
 

About Us

"It's about Radio"

 

Copyright © 2017